When using DataBay, DataVault does not come up recognized. (Also a red light is seen)

  1. Disconnect the drive by shutting down the computer.
  2. Check the jumper settings to see if it is set for internal configuration.
    Olixir FAQ - When using DataBay, DataVault does not come up recognized. (Also a red light is seen)
  3. If not reset them to the correct setting and proceed through the installation
  4. Also check the power switch.

    Picture 4-2

  5. Set the switch to the off position.

Please Enter Your Information to Download the Datasheet

Please Enter Your Information to Download the Datasheet

Please Enter Your Information to Download the Datasheet